Apollo Seiko Robotic Solder Feed Tube

Apollo Seiko solder feed tube connects solder feeder with soldering iron unit, make the solder wire feed to the the tinning area of the iron tip.

Part Numbering Example:

TAL-0.8-650S60

TAL is the tube model

(0.8 is solder diameter in mm)

(650 is total length in mm)

(S60 is stainless steel end length in mm)

Solder feeder tube

Robotic Solder Feed Tube Types:

TR, TAL, TAS, LU

List of TAL Solder Feed Tube

Machine Model P/N for Point Soldering P/N for Slide Soldering
Terra / Luna / L-CAT EVO TAL0.3-450S60
TAL0.4-450S60
TAL0.5-650S60
TAL0.65-1000S60
TAL 1.0-450S60
 TAL0.3-450S90
TAL0.4-450S90
TAL0.5-650S90
TAL0.65-1000S90
TAL0.8-1500S90

* The length of feed tube listed above is for example only. Any of the specified lengths can be ordered with any wire diameter. It is recommended to use shorter tube lengths with smaller wire diameters

Other available tube

TAL**-**WH120

Recommended Posts
Showing 2 comments
  • Patrick Osborne
    Reply

    We are using the following solder tube for our application TAL0.8-1000S60 but we have been getting excessive solder clogs on our EVO robot with (alpha TELE+ 63SN/37PB SOLDER .032” (.0821mm) solder.. Would this be the correct tube selection for this solder diameter?

    • Leisto
      Reply

      The feeder tube is selected according to solder wire, the one you choose it correct. Feeder tube diameter is usually bigger than solder wire, the inner diameter is about 1.0mm.

Leave a Comment

Contact Us

We're not around right now. But you can send us an email and we'll get back to you, asap.